High-Speed Converter Data Source/Capture Boards
Shorten design times by using evaluation boards that quickly showcase the features and performance of selected products. Each evaluation board mates to a data source/capture carrier board, to allow easily capture samples from an ADC or similarly source samples to a DAC. There are two types of data capture kits available, FPGA-based and FIFO-based. Refer to the charts below to determine which kit is the right one for you.
Analog Devices' pattern generators and high-speed DAC evaluation boards are designed and sold solely to support an efficient and thorough means by which to evaluate Analog Devices high speed DACs in a lab environment for a wide range of end applications. Any application or use of the pattern generators and/or high-speed DAC evaluation boards, other than specified above, will not be supported.
- Xilinx Kintex Ultrascale XCKU040-3FFVA1156E FPGA.
- One (1) FMC+ connector.
- Twenty (20) 16Gbps transceivers supported by one (1) FMC+ connector.
- DDR4 SDRAM.
- Simple USB 3.0 port interface.
- Xilinx Virtex-7 XC7VX330T-3FFG1157E FPGA (326,400 logic cells).
- One (1) FMC-HPC connector.
- Ten (10) 13.1 Gbps transceivers supported.
- Two (2) DDR3-1866 DIMMs.
- Simple USB port interface (2.0).
- Based on Virtex-7 FPGA
- Two (2) FMC-HPC connectors
- Ten (10) 13.1 Gbps transceivers per FMC-HPC connector
- Two (2) DDR3-1866 DIMMs
- Simple USB port interface (2.0)
- 256kB FIFO Depth
- Supports multiple ADC channels via single FMC-HPC interface connector
- JESD-204B support for up to eight (8) 6.5Gbps Lanes
- Parallel input at 644 MSPS SDR and 1.2 GSPS DDR
- Use with VisualAnalog® software
- Based on Virtex-6 FPGA
- Simple USB port interface (2.0)
- 256kB FIFO Depth
- JESD-204B support for up to eight (8) 6.5Gbps Lanes
- Parallel input at 644 MSPS SDR and 1.2 GSPS DDR
- Use with VisualAnalog® software
- Based on Virtex-6 FPGA
- Supports multiple ADC channels up to 18 bits
- Simple USB port interface (2.0)
- 64kB FIFO Depth
- Works with single and multi-channel ADCs
- Use with VisualAnalog® software
- Based on Virtex-4 FPGA
- May require adaptor to interface with some ADC eval boards
- Allows programming of SPI control Up to 644 MSPS SDR / 800MSPS DDR Encode Rates on each channel
- DDR Encode Rates on each channel
- 32kB FIFO Depth
- Works with single and dual-channel ADCs
- Use with VisualAnalog® software
- May require adaptor to interface with some ADC eval boards
- Allows programming of SPI control
- Up to 133MSPS Encode Rate
ADC Interposer
- Connects ADI evaluation pinout to FMC interfaces
- Low Pin Count (LPC) connector to connect with LPC or HPC ports
- Compatible with Eval C & Eval D daughter boards
