New Products Listing
Analog Devices is committed to delivering the most innovative products that sense, measure, connect, interpret, power and secure to help you solve your toughest design problems and create solutions that are Ahead of What\'s Possible. The newest products from some of the best designers in the world are listed below.
- All [33]
- A/D Converters (ADC) [7]
- Amplifiers [3]
- D/A Converters (DAC) [1]
- Interface & Isolation [7]
- Power Management [4]
- Power Monitor, Control, & Protection [4]
- RF & Microwave [6]
- Switches & Multiplexers [1]
A/D Converters (ADC) [7]
Single Supply, Multichannel, 31.25 kSPS, 24-Bit, Sigma-Delta ADC with ±10 V Inputs
Recommended for New Designs
Dual, Simultaneous Sampling, 14-Bit, 4 MSPS, SAR ADCs, Pseudo Differential Input
Recommended for New Designs
Dual, Simultaneous Sampling, 16-Bit, 4 MSPS, SAR ADCs, Pseudo Differential Input
Recommended for New Designs
Single-Supply, Multichannel, 125 kSPS, 24-Bit, Sigma-Delta ADC with ±10 V Inputs
Recommended for New Designs
MxFE Quad, 16-Bit, 12 GSPS RF DAC and Dual, 12-Bit, 6 GSPS RF ADC
Recommended for New Designs
Amplifiers [3]
36V Fully-Differential Programmable-Gain Instrumentation Amplifier with 25pA Input Bias Current
Recommended for New Designs
Quad 10μA Supply Current, Low IB, Zero-Drift Operational Amplifier
Recommended for New Designs
D/A Converters (DAC) [1]
Interface & Isolation [7]
5.7 kV rms, Signal Isolated, High Working Voltage, CAN FD Transceiver with ±15kV IEC ESD
Recommended for New Designs
Single-Channel, 16-Bit, Current/Voltage Output DAC, Functional Safety Approved for Unipolar Current Output
Recommended for New Designs
5.7 kV RMS Isolated, High Working Voltage, RS-485 Transceiver with ±15 kV IEC ESD
Recommended for New Designs
5.7 kV RMS Isolated, High Working Voltage, RS-485 Transceiver with ±15 kV IEC ESD
Recommended for New Designs
500 kbps, 5.7 kV RMS, Signal Isolated Half Duplex RS-485 Transceiver with ±15 kV IEC ESD
Recommended for New Designs
500 kbps, 5.7 kV RMS, Signal Isolated Full Duplex RS-485 Transceiver with ±15 kV IEC ESD
Recommended for New Designs
5.7 kV RMS 500kbps Full Duplex Signal and Power Isolated RS-485 Transceiver with ±15 kV IEC ESD
Recommended for New Designs
Power Management [4]
Synchronous Boost μModule Regulator with Input-Output Short Protection
Recommended for New Designs
60V Synchronous 4-Switch Buck-Boost Controller with Spread Spectrum
Recommended for New Designs
Power Monitor, Control, & Protection [4]
Isolated, Half Bridge Gate Driver with Adjustable Dead Time, Single Input, 4 A Output
Recommended for New Designs
Isolated, Half Bridge Gate Driver with Adjustable Dead Time, Dual Input, 4 A Output
Recommended for New Designs
RF & Microwave [6]
10 GHz to 40 GHz, 4-Channel Rx Mixer with 4× LO Multiplier/Filter
Recommended for New Designs
Switches & Multiplexers [1]
Fault Protection, 6 Ω RON, SPST Switch with 0.6 kΩ Feedback Channel
Recommended for New Designs
English
简体中文
日本語
Руccкий
