LTC6605-7

LAST TIME BUY

Dual Matched 7MHz Filter with Low Noise, Low Distortion Differential Amplifier

Data Sheet Product Selection Table
Viewing:

Overview

  • Two Matched 7MHz 2nd Order Lowpass Filters with Differential Amplifiers
    • Gain Match: ±0.35dB Max, Passband
    • Phase Match: ±1.2° Max, Passband
    • Single-Ended or Differential Inputs
  • < –90dBc Distortion in Passband
  • 2.1nV/√Hz Op Amp Noise Density
  • Pin-Selectable Gain (0dB/12dB/14dB)
  • Pin-Selectable Power Consumption (0.35mA/16.2mA/33.1mA)
  • Rail-to-Rail Output Swing
    • Adjustable Output Common Mode Voltage Control
    • Buffered, Low Impedance Outputs
  • 2.7V to 5.25V Supply Voltage
  • Small 22-Pin 6mm × 3mm × 0.75mm DFN Package

The LTC6605-7 contains two independent, fully differential amplifiers configured as matched 2nd order lowpass filters. The f–3dB of the filters is adjustable in the range of 6.5MHz to 10MHz.

The internal op amps are fully differential, feature very low noise and distortion, and are compatible with 16-bit dynamic range systems. The inputs can accept single ended or differential signals. An input pin is provided for each amplifier to set the common mode level of the differential outputs.

Internal laser-trimmed resistors and capacitors determine a precise, very well matched (in gain and phase) 7MHz 2nd order filter response. A single optional external resistor per channel can tailor the frequency response for each amplifier.

Three-state BIAS pins determine each amplifier’s power consumption, allowing a choice between shutdown, medium power or full power.

The LTC6605-7 is available in a compact 6mm × 3mm 22-pin leadless DFN package and operates over a –40°C to 85°C temperature range.

Applications

  • WCDMA ADC Driver/Filter
  • Antialiasing Filter
  • Single-Ended to Differential Conversion
  • DAC Smoothing Filter
  • Zero-IF Direct Conversion Receivers
LTC6605-7
Dual Matched 7MHz Filter with Low Noise, Low Distortion Differential Amplifier
Dual, Matched 6.5MHz Lowpass Filter Channel to Channel Phase Matching Product Package 1
Add to myAnalog

Add product to the Products section of myAnalog (to receive notifications), to an existing project or to a new project.

Create New Project
Ask a Question

Documentation

Data Sheet 1

Reliability Data 1

User Guide 1

Design Note 1

Technical Articles 1

Data Sheet

This is the most up-to-date revision of the Data Sheet.

Learn More
Add to myAnalog

Add media to the Resources section of myAnalog, to an existing project or to a new project.

Create New Project

Software Resources

Can't find the software or driver you need?

Request a Driver/Software

Hardware Ecosystem

Parts Product Life Cycle Description
LT6604-5
RECOMMENDED FOR NEW DESIGNS Dual Very Low Noise, Differential Amplifier and 5MHz Lowpass Filter
Modal heading
Add to myAnalog

Add product to the Products section of myAnalog (to receive notifications), to an existing project or to a new project.

Create New Project

Tools & Simulations

LTspice

Models for the following parts are available in LTspice:

  • LTC6605-10
  • LTC6605-14
  • LTC6605-7
LTspice

LTspice® is a powerful, fast and free simulation software, schematic capture and waveform viewer with enhancements and models for improving the simulation of analog circuits.

Evaluation Kits

eval board
schematic 1
DC1422A-A

LTC6605-7 | Dual Matched 7MHz Low Noise, Low Distortion 2nd Order LP Filter

Buy Now View Details

Product Details

DC1422A-A: Demo Board for the LTC6605-7 Dual Matched 7MHz Filter with Low Noise, Low Distortion Differential Amplifier.
DC1422A-A
LTC6605-7 | Dual Matched 7MHz Low Noise, Low Distortion 2nd Order LP Filter
DC1422A-A - Schematic

Latest Discussions

No discussions on LTC6605-7 yet. Have something to say?

Start a Discussion on EngineerZone®

Recently Viewed