MAX19005

PRODUCTION

Quad, Ultra-Low-Power, 200Mbps ATE Drivers/Comparators

Low-Cost, Low-Power ATE Pin Electronics for Memory, Burn-In, and Structural Automated Test Equipment

Data Sheet (Rev. 0) Product Selection Table
Viewing:

Overview

  • Small Footprint: Four Channels in 0.3in²
  • Low-Power Dissipation: 340mW/Channel (typ)
  • High Speed: 200Mbps at 3VP-P
  • -1V to +5.2V Operating Range
  • Integrated Pin Switch (with -1V to +24V Off Range)
  • Integrated PMU Switches with -1V to +24V Operating Range
  • Passive Load
  • Low-Leakage Mode by Pin Switch Off: 10nA (max)
  • Low Gain and Offset Error

The MAX19005 four-channel, ultra-low-power, pin-electronics IC includes a two-level pin driver, a window comparator, a passive load, and force-and-sense Kelvin-switched parametric measurement unit (PMU) connections for each channel. The driver features a -1V to +5.2V voltage range, includes high-impedance modes, and is highly linear even at low voltage swings. The window comparator features 240MHz equivalent input bandwidth and programmable output voltage levels. The passive load provides pullup and pulldown voltages to the device-under-test (DUT).

Low leakage and high impedance are operational configurations that are programmed through a 3-wire, low-voltage, CMOS-compatible serial interface. High-speed PMU switching is realized through dedicated digital control inputs.

This device is available in an 80-pin, 12mm x 12mm body, 0.5mm pitch TQFP with an exposed 6mm × 6mm die pad on the bottom of the package for efficient heat removal. The device is specified to operate over the 0°C to +70°C commercial temperature range and features a die temperature monitor output.

Applications

  • Active Burn-In Systems
  • DRAM Probe Testers
  • Low-Cost Mixed-Signal/System-on-Chip (SoC) Testers
  • NAND Flash Testers
  • Structural Testers
MAX19005
Quad, Ultra-Low-Power, 200Mbps ATE Drivers/Comparators
MAX19005: Block Diagram
Add to myAnalog

Add product to the Products section of myAnalog (to receive notifications), to an existing project or to a new project.

Create New Project
Ask a Question

Documentation

Data Sheet 1

Reliability Data 1

Technical Articles 1

Learn More
Add to myAnalog

Add media to the Resources section of myAnalog, to an existing project or to a new project.

Create New Project

Hardware Ecosystem

Parts Product Life Cycle Description
Automatic Test Equipment (ATE) 2
MAX9972
PRODUCTION Quad, Ultra-Low-Power, 300Mbps ATE Drivers/Comparators
MAX9979
PRODUCTION Dual 1.1Gbps Pin Electronics with Integrated PMU and Level-Setting DACs
Modal heading
Add to myAnalog

Add product to the Products section of myAnalog (to receive notifications), to an existing project or to a new project.

Create New Project

Latest Discussions

No discussions on MAX19005 yet. Have something to say?

Start a Discussion on EngineerZone®

Recently Viewed