o  Attached ADRV9001_S-parameters_ver.01.zip are S-parameter files for ADRV9001 RF ports.
     	External LO 2 port S-parameter - extLO_spar_50ohm.s2p
     	RxA 2 port S-parameter - rxa_spar_50ohm.s2p
     	RxB 2 port S-parameter - rxb_spar_50ohm.s2p
     	Tx 2 port S-parameter - tx_spar_50ohm.s2p
     Those 2 port S-parameter files include:
            package bumps,
            laminate traces
            chip input impedances
               -  For RX, attenuation set to minimum (maximum Rx data path gain  minimum attenuation before mixer).
               -  For TX, attenuation set to minimum (lowest attenuation at the Tx output  biggest swing  minimum attenuation after mixer)
o  For RF matching network simulations there are 1 port and 4 port S-parameter files included. 
     	External LO laminate S-parameter - extLO_laminate.s4p
     	External LO 1 port S-parameter - extLO_port.s1p
     	Rx port laminate S-parameter - rx_laminate.s4p
     	Rx port 1 port S-parameter - rx_port_attn_0db.s1p
     	Tx port laminate S-parameter - tx_laminate.s4p
     	Tx port 1 port S-parameter - tx_port_attn_0db.s1p
     The differential port S-parameters were measured differentially but are supplied here in an S1P format. For information on how to use these files use this Tutorial guide 
     https://ez.analog.com/wide-band-rf-transceivers/tes-gui-software-support-adrv9001-adrv9007/w/documents/17582/ads-simulation-of-matching-networks 