======================================================================
                            - TrekIce - 
                    Trek-Ice Ethernet JTAG Emulator
                 
                           Version 1.10.0
                         
                           Analog Devices
   ADI DSPs feature the White Mountain Line of DSP Development Tools
======================================================================

        Trek-Ice is a SHARC JTAG Debug Target for Visual-DSP 4.1.x 
        and Visual-DSP++ 1.00 or greater.  It will provide full JTAG 
        debug support for all 2106x and 2116x processors using an 
        external emulator through an ethernet network.

======================================================================
        Requirements
======================================================================

        - VisualDSP 4.1.x and VisualDSP++1.00 or greater.
        
                NOTE: Version 4.1.x is still supported but the new 
                statistical profiling feature will not be available.
                  
        - A Trek-ICE JTAG Emulator
        
        - Windows 95B, Windows 98, Windows NT 4.0 SP3
          or greater, or Windows 2000.
        
======================================================================
        Installation and Usage Notes
======================================================================
        - After installation the TrekControl utility must be run to 
          to setup registry entries.
        
        - After installation the ICE Configurator utility MUST be run
          before starting a debug session.      

        - When switching between different target boards be sure to
          first close the current debugger session, then move the
          emulator pod to the new target and finally start a new debugger
          session on the new target.  "Hot swapping" between different
          target boards using "New Session" or "Select Session" from the 
          debugger menu is not supported by the ICE.

======================================================================
        Upgrade from version 1.00.0 or 1.00.1
======================================================================

        - After installation, launch TrekControl.exe to connect to Trek.  
          Download the files SharcSocStubCE.exe and WmSharcIceCE.dll to 
          the Trek. Reboot Trek. 

======================================================================
        Features/Bug fixes in this release
======================================================================
        - New features:
                * The Sharc 21161 target option has been added.

        - Bug fixes:
                * When creating a multi-processor session and it 
                  contains unknown processors is now fixed.
        
======================================================================
        Known Issues
======================================================================

        - Physically resetting the target processor is not supported 
          while the ICE is connected and halted.  If a reset must be 
          applied then the target should be in a running state or the
          debugger should first be exited.

        - Memory fills using the "Memory->Fill..." command on either a 
          2106x or a 2116x will not be verified when "Verify all writes
          to target memory" is checked in the Target Options dialog.
          Loading programs and manually entering data into memory
          windows will be properly verified.
          
        - 2116x PEy multiplier registers display the PEx multiplier
          register values.  Internal operation of these registers is 
          unaffected.
        
        - 2116x MS cycle counter register is not displayed properly.
        
        - Scrolling through MP memory regions on a 2106x device may 
          cause the debugger to display invalid data in memory and 
          register windows.  To fix this, simply refresh the windows 
          (F12 or Window->Refresh) and the correct data will be 
          reloaded from the target.
        
======================================================================
        Change Log
====================================================================== 

        1.00.2
                - Added statistical profiling (under VisualDSP++ 1.0)
                - Improvements for debugging multiprocessor targets.
                - Fixed Core Hang bugs during startup and loading.