======================================================================
                          - Wm21020Ice - 
                 ADSP-21020 JTAG Emulator Debug Target DLL
                 
                          Version 1.00.1
                          
                        Analog Devices, Inc.
======================================================================

        Wm21020Ice is a SHARC JTAG Debug Target for VisualDSP++ 2.00,
        or greater.  It will provide full JTAG debug support for 
        21020x processors using an external emulator such as the 
        ADSP-21020 EZ-ICE from Analog Devices.

======================================================================
        Requirements
======================================================================

        - VisualDSP++ 2.0, or greater with 21020 (SHARC) support.
                  
        - A ADSP-21020 EZ-ICE Emulator.
        
        - Windows 95 OSR2, Windows 98, Windows NT 4.0 with SP3 or greater,
          or Windows 2000.
        
======================================================================
        Installation and Usage Notes
======================================================================
                  
        - Operation under Windows NT or Windows 2000 requires the proper 
          JTAG Emulator Driver to be installed and running.  This driver
          software is integrated into the Emulation Tools setup.
                
        - After installation the JTAG ICE Configurator utility MUST be
          run before starting a debug session.
          
        - When switching between different target boards be sure to
          first close the current debugger session, then move the
          emulator pod to the new target and finally start a new debugger
          session on the new target.  "Hot swapping" between different
          target boards using "New Session" or "Select Session" from the 
          debugger menu is not supported by the ICE.

======================================================================
        Features in this release
======================================================================

        - Fixed some issues so that we can work with the new configurator
        
======================================================================
        Known Issues
======================================================================

        - Physically resetting the target processor is not supported 
          while the ICE is connected and halted.  If a reset must be 
          applied then the target should be in a running state or the
          debugger should first be exited.

          
======================================================================
        Change Log
======================================================================