Features and Benefits
- Microwave Envelope tracking detector
- Envelope output bandwidth: 500 MHz
- Differential 100Ω Envelope output
- Broadband 50 Ω input impedance
- Accurate response from 2 GHz to 43.5 GHz with minimal slope variation
- Input range of −10 dBm to +15 dBm low power consumption: 26 mA at 5 V
- 3 mm × 2 mm, 10-lead LFCSP package
The ADL6012 is a versatile, broadband Envelope detector covering the microwave frequencies from 2 to 43.5 GHz. It provides state-of-the-art accuracy with low power consumption (90 mW) in a simple, easy to use 10-lead LFCSP package. The envelope output is pseudo-differential with 500MHz BW, 100Ω differential output impedance and variable common-mode capability.
The detector cell uses a proprietary Schottky diode array to extract both the positive and the negative envelopes of the RF signal. These two envelope voltages are buffered and level shifted using an externally applied VOCM voltage and presented on the ENVP and ENVM pins. The envelope outputs are designed to drive 400 Ω differential load and up to 2pF of capacitance to ground on each output. The envelope output bears the signature of typical diode non-linearity and has 20dB linear range at the top end.
The input power can range from −10 dBm to +15 dBm.
A subtle aspect of the balanced detector topology used in ADL6012 is that even-order distortion, caused by nonlinear source loading, at the input is substantially reduced compared with a simple diode detector. This is an important benefit in applications where a low ratio coupler is used to extract a signal sample. This s a significant improvement over traditional diode detectors.
The Envelope output can be used to detect and correct LO leakage in IQ modulators in point-to-point Microwave radios, employing higher order QAM modulations, where LO leakage in the transmit signal causes EVM degradation. The ADL6012 envelope detector outputs can also be used in extremely fast signal detection applications where log or RMS responding detection capability, is not needed.
The ADL6012 is specified for operation from −40°C to +85°C. The ADL6012 is available in a 10-lead, 3 mm × 2 mm LFCSP package.
- Microwave point to point links
- Microwave instrumentation
- Radar-based measurement systems
Product Lifecycle Pre-Release
This product is new and engineering validation may still be underway. Quantities may be limited and design specifications may change while we ready the product for release to production.
Evaluation Kits (1)
ADL6012-EVALZ is a fully populated, 4-layer, FR4-based evaluation board. For normal operation, it requires a 3.3 V or 5 V power supply. The 5 V power supply should be connected to the VPOS and GND test loops. The RF input and load should be applied to the RFIN 2.92 mm connector. The differential envelope output signal is available on the connectors labeled VRMS_ENV+ and NCON_VEV-.
ADI has always placed the highest emphasis on delivering products that meet the maximum levels of quality and reliability. We achieve this by incorporating quality and reliability checks in every scope of product and process design, and in the manufacturing process as well. "Zero defects" for shipped products is always our goal.
Sample & Buy
The USA list pricing shown is for BUDGETARY USE ONLY, shown in United States dollars (FOB USA per unit for the stated volume), and is subject to change. International prices may differ due to local duties, taxes, fees and exchange rates. For volume-specific price or delivery quotes, please contact your local Analog Devices, Inc. sales office or authorized distributor. Pricing displayed for Evaluation Boards and Kits is based on 1-piece pricing.