Overview

Features and Benefits

  • Small 6.4 mm × 7.2 mm solution
  • 2.2 μH power inductor 
  • 92% peak efficiency 
  • Tx masking within 50 μs 
  • 2.1 A, 12 V power switch
  • Pin-selectable interface: 2-bit logic or I2C
  • Programmable flash and torch current
    • Up to 200 mA in torch mode
    • Up to 500 mA in flash mode 
  • Programmable indicator LED current up to 20 mA
  • Programmable timer register: up to 820 ms flash timeout 
  • 2.75 V to 5.5 V input voltage range
  • Low noise, 1.2 MHz PWM operation
  • Safety features
    • Interrupt output pin
    • Fault condition register 
    • Short-circuit protection
    • Output overvoltage protection
    • Thermal overload protection
    • Integrated current limit and soft start 
  • Small 3 mm × 3 mm, 16-lead LFCSP footprint

Product Details

The ADP1653 is a very compact, high efficiency, high power, camera flash LED driver optimized for cellular phones. The high efficiency and dynamic LED current control of the device improve flash brightness and picture quality in dimly lit environments. Efficiency peaks at 92% and is higher than charge pump solutions over the Li-Ion battery range.

The device has a dual-mode interface that is configurable to 2-bit logic or an I2C® interface. The indicator and high power LED currents are programmable with external resistors or through the I2C interface. To maximize overall flash brightness, the ADP1653 offers an input to reduce flash LED current in less than 50 μs, referred to as the Tx mask. Tx masking reduces battery stress by scaling back flash LED current during an RF transmission.

The ADP1653 solution requires only four external components in I2C mode and fits in a 6.4 mm × 7.2 mm space. The part integrates multiple safety features such as soft start, flash timeout, output current limit, thermal protection, and overvoltage protection.

The ADP1653 operates over the −40°C to +125°C junction temperature range.

Applications

  • Camera-enabled cellular phones, smart phones
  • Digital still cameras, camcorders, PDAs

Product Lifecycle icon-not-recommended Not Recommended for New Designs

This designates products ADI does not recommend broadly for new designs.

Evaluation Kits (1)

Design Resources

ADI has always placed the highest emphasis on delivering products that meet the maximum levels of quality and reliability. We achieve this by incorporating quality and reliability checks in every scope of product and process design, and in the manufacturing process as well.  "Zero defects" for shipped products is always our goal.