The AD596/AD597 is a monolithic temperature setpoint controller which has been optimized for use at elevated temperatures such as those found in oven control applications. The device cold junction compensates and amplifies a type J or K thermocouple input to derive an internal signal proportional to temperature. The internal signal is then compared with an externally applied setpoint voltage to yield a low impedance switched output voltage. Dead-Band or switching hysteresis can be programmed using a single external resistor. Alternately, the AD596/ AD597 can be configured to provide a voltage output (10 mV/°C) directly from a type J or K thermocouple signal. It can also be used as a stand-alone voltage output temperature sensor.

The AD596/AD597 can be powered with a single supply from +5 V to +30 V, or dual supplies up to a total span of 36 V. Typical quiescent supply current is 160 µA which minimizes self-heating errors.

The AD596/AD597 H package option includes a thermocouple failure alarm that indicates an open thermocouple lead when operated in the temperature proportional measurement mode. The alarm output has a flexible format which can be used to drive relays, LEDs or TTL logic.

The device is packaged in a reliability qualified, cost effective 10-pin metal can, 8-pin plastic mini-DIP or SOIC and is trimmed to operate over an ambient temperature range from +25°C to +100°C. Operation over an extended ambient temperature range is possible with slightly reduced accuracy. The AD596 will amplify thermocouple signals covering the entire -200°C to +760°C temperature range recommended for type J thermocouples while the AD597 can accommodate -200°C to +1250°C type K inputs.

The AD596/AD597 has a calibration accuracy of ±4°C at an ambient temperature of 60°C and an ambient temperature stability specification of 0.05°C/°C from +25°C to +100°C. If higher accuracy, or a lower ambient operating temperature is required, either the AD594 (J thermocouple) or AD595 (K thermocouple) should be considered.

*Protected by U.S. Patent No. 4,029,974.

Part#	Temp Res(°C/LSB)	25°C Temp Error (Deg C)	Resolution (Bits)	# Chan	DAC Outputs	Interface	Temp Range(s)	Supply Voltage Range	Product Description	Price* (1000-4999)
ADT7316	0.25	±0.5	10	3	12-Bit x 4	I2C, I2C/SPI, Serial, SM Bus, SPI	-40 to +120	+2.7V to +5.5V	SPI/I2C® Compatible,10-Bit Digital Temperature Sensor With Quad Voltage-Output 12-Bit DAC	$6.38
ADT7317	0.25	±0.5	10	3	10-Bit x 4	I2C, I2C/SPI, SM Bus, SPI	-40 to +120	+2.7V to +5.5V	SPI/I2C® Compatible,10-Bit Digital Temperature Sensor w/ Quad 10-Bit Voltage Output DAC	$3.47
ADT7318	0.25	+0.5	10	3	8-Bit x 4	I2C, I2C/SPI, Serial, SM Bus, SPI	-40 to +120	+2.7V to +5.5V	SPI/I2C® Compatible,10-Bit Digital Temperature Sensor & Quad Voltage Output 8-Bit DAC	$2.20
TMP03	0.3	±3	16	0	---	PWM	-40 to +100	+4.5V to +7V	Serial PWM-Output Temperature Sensor w/ Open-Collector Output	$3.23
TMP04	0.3	±3	16	0	---	PWM	-40 to +100	+4.5V to +7V	Serial PWM-Output Temperature Sensor w/ CMOS/TTL Output	$3.23
AD7814	0.25	n/a	10	0	---	Serial, SPI	-55 to +125	+2.7V to +5.5V	10-Bit Digital Temperature Sensor in 6-Lead SOT-23	$0.99
AD7414	0.25	n/a	10	0	---	I2C, Serial	-40 to +125	+2.7V to +5.5V	SMBus/I2C, 10-Bit Digital Temperature Sensor in 6-Pin SOT w/ SMBus Alert and Over-Temperature Pin	$1.03
AD7415	0.25	±2	10	0	---	I2C, Serial	-40 to +125	+2.7V to +5.5V	SMBus/I2C, 10-Bit Digital Temperature Sensor in 5-Pin SOT	$1.03
AD7416	0.25	n/a	10	0	---	Switch (Off/On)	-40 to +125	+2.7V to +5.5V	10-Bit Temperature-to-Digital Converter, -40°C to +125°C, ±2°C Accuracy	$0.99
AD7816	0.25	±1	10	0	---	Serial, SPI, Switch (Off/On)	-40 to +85	+2.7V to +5.5V	10-Bit Digital Output Temperature Sensor w/Over-Temp Alert and Auto Pwr Dwn @ End of Conversion	$1.43
AD7314	0.25	±1	10	0	---	Serial, SPI	-35 to +85	+2.65V to +5.5V	Low Voltage, 10-Bit Digital Temperature Sensor in 8-Lead µSOP	$0.65
AD7818	0.25	±1	10	1	---	Switch (Off/On)	-40 to +85	+2.7V to +5.5V	9 µs, 10-Bit ADC w/ On-Chip Temperature Sensor & Over-Temperature Output	$2.31
AD7418	0.25	±1	10	2	---	I2C, Serial, Switch (Off/On)	-40 to +125	+2.7V to +5.5V	10-Bit ADC, Programmable Hi-Low Temp Limits w/ Over-Temp Alert, , Auto Pwr Dwn @ EOC	$2.31
AD7817	0.25	±1	10	4	---	Switch (Off/On)	-40 to +85	+2.7V to +5.5V	4-Channel, 9 µs, 10-Bit ADC with On-Chip Temperature Sensor & Over-Temperature Flag	$3.25
AD7417	0.25	±1	10	5	---	I2C, Serial, Switch (Off/On)	-40 to +125	+2.7V to +5.5V	4-Channel, 10-Bit ADC w/ on-Chip Temperature Sensor, Programmable Setpoints, and Overtemp Flag Out	$2.95
ADT7516	0.25	n/a	10	7	12-Bit x 4	I2C/SPI, Serial, SPI	-40 to +120	+2.7V to +5.5V	SPI/I2C Compatible Temperature Sensor w/10-Bit-4-Ch ADC & Quad 12-Bit Voltage DAC Control Outputs	$7.65
ADT7411	0.25	+0.5	10	11	n/a	I2C, I2C/SPI, Serial, SPI	-40 to +120	+2.7V to +5.5V	SPI®-/I2C®-Compatible, 10-Bit ADC w/ Local & Remote Temp Msmt, 8 GP Analog Inputs, and VDD monitor	$2.19
ADT6501	0.125	±4	11	n/a	-	Switch (Off/On)	-55 to +125	+2.7V to +5.5V	2.7V/5.5V, Micropower Temperature Switch in SOT-23 w/ active-low open-drain Output, +35 to +115 DegC	$0.49
ADT6502	0.125	±4	11	n/a	---	Switch (Off/On)	-55 to +125	+2.7V to +5.5V	2.7V/5.5 V, Micropower Temperature Switch in SOT-23 w/Active-High Push-pull Output, +35 to +115 DegC	-
ADT6503	0.0625	n/a	11	n/a	---	Switch (Off/On)	-55 to +125	+2.7V to +5.5V	2.7V/5.5V, Micropower Temperature Switch in SOT-23 w/Open-drain Output, -45 to +15 Deg C	$0.49
ADT6504	0.0625	n/a	12	n/a	---	Switch (Off/On)	-55 to +125	+2.7V to +5.5V	2.7 V to 5.5 V, Micropower Temperature Switch in SOT-23 w/Push-pull Output, -45 to +15 Deg C	$0.49
ADT7408	0.0625	±1	12	0	---	Switch (Off/On)	-20 to +125	+3V to +3.6V	± 2 Degree C Accurate, 12-Bit Digital Temperature Sensor	$0.86
ADT75	0.0625	n/a	12	0	---	Switch (Off/On)	-55 to +125	+3V to +5.5V	±1 Deg C Accuracy, 12-Bit Digital Temperature Sensor	$0.65
ADT7301	0.03125	n/a	13	0	---	Serial, SPI	-40 to +150	+2.7V to +5.5V	13-Bit, ±1ºC Accurate, MicroPower Digital Temperature Sensor in 6-Lead SOT-23 and 8-Lead MSOP	$1.20
ADT7302	0.03125	n/a	13	0	---	Serial, SPI	-40 to +125	+2.7V to +5.25V	±2°C Accurate, MicroPower Digital Temperature Sensor in 6-Lead SOT-23	$0.62
TMP06	0.025	±0.5	12	0	---	PWM	-40 to +150	+2.7V to +5.5V	0.5°C Accurate PWM Temperature Sensor in 5-Lead SC-70 or SOT-23 w/ Open Drain Output	$0.65
TMP01	n/a	±0.5	n/a	0	---	Analog, Switch (Off/On)	-55 to +125	+4.5V to +13.2V	Low Power, Programmable Temperature Sensor/ Controller w/ upper/lower setpoints	$2.64
TMP05	0.025	±0.5	12	0	---	PWM	-40 to +150	+2.7V to +5.5V	0.5°C Accurate PWM Temperature Sensor in 5-Lead SC-70 or SOT-23 w/ CMOS/TTL Output	$0.65
AD22105	n/a	±3	n/a	0	---	Switch (Off/On)	-40 to +125	+2.7V to 7V	Low Voltage, Resistor Programmable Thermostatic Switch	$1.20

* The pricing listed here is provided only for budgetary purposes as recommended list price in U.S. Dollars in the United States ex factor per unit for the stated volume. Pricing displayed for Evaluation Boards and Kits is based on 1-piece pricing.
** Pricing is currently unavailable. Click on the product number to see the Product Page for additional information.

The model number is a specific version of a generic that can be purchased or sampled.

Status indicates the current lifecycle of the product. This can be one of 4 stages:

• Pre-Release: The model has not been released to general production, but samples may be available.
• Production: The model is currently being produced, and generally available for purchase and sampling.
• Last Time Buy: The model has been scheduled for obsolescence, but may still be purchased for a limited time.
• Obsolete: The specific part is obsolete and no longer available. Other models listed in the table may still be available (if they have a status that is not obsolete).

The package for this IC (i.e. DIP, SOIC, BGA). An Evaluation Board is a board engineered to show the performance of the model, the part is included on the board.

For detailed drawings and chemical composition please consult our  Package Site

Pin Count is the number of pins, balls, or pads on the device. Pin-out diagrams & pin function descriptions may be found in the datasheet.

This is the acceptable operating range of the device. The various ranges specified are as follows:

• Commercial: 0 to +70 degrees Celsius
• Military : -55 to +125 degrees Celsius
• Industrial: Temperature ranges may vary by model. Please consult the datasheet for more information.
• Automotive: -40 to +125 degrees Celsius

The USA list pricing shown is for BUDGETARY USE ONLY, shown in United States dollars (FOB USA per unit for the stated volume), and is subject to change. International prices may differ due to local duties, taxes, fees and exchange rates. For volume-specific price or delivery quotes, please contact your local Analog Devices, Inc. sales office or authorized distributor. Pricing displayed for Evaluation Boards and Kits is based on 1-piece pricing.

This is the date Analog Devices, Inc. anticipates that the product will ship from the warehouse. Most orders ship within 48 hours of this date.Once an order has been placed, Analog Devices, Inc. will send an Order Acknowledgement email to confirm your delivery date. It is important to note the scheduled dock date on the order entry screen. We do take orders for items that are not in stock, so delivery may be scheduled at a future date. Also, please note the warehouse location for the product ordered. We have warehouses in the United States, Europe and Southeast Asia. Transit times from these sites may vary.

Due to environmental concerns, ADI offers many of our products in lead-free versions. For more information about lead-free parts, please consult our Pb (Lead) free information page.