|
| Chapter: 22 |
Page: 42 |
| Reference Number: 36382 |
| Change |
In figure 22-12 (SPI Control Register), the description of CPHA=1 needs to change from: 1 - SCK toggles from beginning of first data bit, slave select pins controller by hardware
Change to: 1 - SCK toggles from beginning of first data bit, slave select pins controller by software |
back to top |
|
| Chapter: 22 |
Page: 42 |
| Reference Number: 39588 |
| Change |
In figure 22-12 (SPI Control Register), the CPHA bit =1 definition should be:
1 - SCK toggles from beginning of first data bit, slave select pins controlled by software |
back to top |
|
| Chapter: 23 |
Page: 22 |
| Reference Number: 35624 |
| Change |
In figure 23-11 (TWI Master Mode), eliminate the block of text that reads: WRITE TO TWI_SLAVE_CTL TO
ENABLE SLAVE FUNCTIONALITY
Note that this block of text correctly appears in other figure on this page (TWI Slave Mode). |
back to top |
|
