|
| Chapter: N/A |
Page: 26 |
| Reference Number: 36885 |
| Change |
| The Test Conditions column entry for IDDHIBERNATE in the Electrical Characteristics table is missing the condition "CLKIN = 0 MHz". Add this condition to the entry. |
back to top |
|
| Chapter: N/A |
Page: 34 |
| Reference Number: 36746 |
| Change |
In table 24 (External Late Frame Sync), the table refers to the multi-channel enable bit as MCE (incorrect) rather that MCMEN (correct). Change the following: - In the tDDTLFSE specification, change MCE = 1 to MCMEN = 1
- In the tDTENLFS specification, change MCE = 1 to MCMEN = 1
- In footnote 1, change MCE = 1 to MCMEN = 1
|
back to top |
|
| Chapter: N/A |
Page: 39 |
| Reference Number: 36748 |
| Change |
In table 29 (External Late Frame Sync), the table refers to the multi-channel enable bit as MCE (incorrect) rather that MCMEN (correct). Change the following: - In the tDDTLFSE specification, change MCE = 1 to MCMEN = 1
- In the tDTENLFS specification, change MCE = 1 to MCMEN = 1
- In footnote 1, change MCE = 1 to MCMEN = 1
|
back to top |
|
| Chapter: N/A |
Page: 40 |
| Reference Number: 36745 |
| Change |
In table 32 (External Late Frame Sync), the table refers to the multi-channel enable bit as MCE (incorrect) rather that MCMEN (correct). Change the following: - In the tDDTLFSE specification, change MCE = 1 to MCMEN = 1
- In the tDTENLFS specification, change MCE = 1 to MCMEN = 1
- In footnote 1, change MCE = 1 to MCMEN = 1
|
back to top |
|
| Chapter: N/A |
Page: 42 |
| Reference Number: 36749 |
| Change |
In table 28 (External Late Frame Sync), the table refers to the multi-channel enable bit as MCE (incorrect) rather that MCMEN (correct). Change the following: - In the tDDTLFSE specification, change MCE = 1 to MCMEN = 1
- In the tDTENLFS specification, change MCE = 1 to MCMEN = 1
- In footnote 1, change MCE = 1 to MCMEN = 1
|
back to top |
|
| Chapter: N/A |
Page: 51 |
| Reference Number: 36747 |
| Change |
In table 36 (External Late Frame Sync), the table refers to the multi-channel enable bit as MCE (incorrect) rather that MCMEN (correct). Change the following: - In the tDDTLFSE specification, change MCE = 1 to MCMEN = 1
- In the tDTENLFS specification, change MCE = 1 to MCMEN = 1
- In footnote 1, change MCE = 1 to MCMEN = 1
|
back to top |
|
