D/A Converters : Application Notes
-
AN-1036: Clear to Any Voltage Using the AD5370
(pdf, 74 kB)
-
AN-0986: Adjusting the Output Range and Span of the AD5362
(pdf, 79 kB)
-
AN-0982: The Residual Phase Noise Measurement
(pdf, 710 kB)
-
AN-928: Understanding High Speed DAC Testing and Evaluation
(pdf, 4445 kB)
-
AN-920: Gain, LO, and Phase Compensation in a Single Sideband Transmitter Using the AD9788 TxDAC and ADL5372 Quadrature Modulator
(pdf, 232 kB)
-
AN-919: AD9779A/AD9788: Guaranteeing PLL Lock Over Temperature
(pdf, 74 kB)
-
AN-912: Driving a Center-Tapped Transformer with a Balanced Current-Output DAC
(pdf, 246 kB)
-
AN-834: AD9786/AD9726 Calibration Engine
(pdf, 354 kB)
-
AN-822: Synchronization of Multiple AD9779 TxDACs
(pdf, 129 kB)
-
AN-808: Multicarrier CDMA2000 Feasibility
(pdf, 1535 kB)
The goal of this application note is to determine the feasibility of implementing a multicarrier CDMA2000 transceiver and what the major subsystem performances must be.
-
AN-772: A Design and Manufacturing Guide for the Lead Frame Chip Scale Package (LFCSP)
(pdf, 439 kB)
-
AN-759: Expanding the Number of DAC Outputs on the ADuC8xx and ADuC702x Families (uC012)
(pdf, 112 kB)
-
AN-748: Set-Up and Hold Measurements in High Speed CMOS Input DACs
(pdf, 812 kB)
-
AN-747: Timing Synchronization for Multiple AD9786 TxDACs
(pdf, 2389 kB)
-
AN-642: Coupling a Single-Ended Clock Source to the Differential Clock Input of Third-Generation TxDAC® and TxDAC+® Products
(pdf, 479 kB)
-
AN-640: 0: Synchronizing Multiple AD9777s Using DATACLK Input Mode
(pdf, 61 kB)
-
AN-595: Understanding Pin Compatibility in the TxDAC® Line of High Speed D/A Converters
(pdf, 36 kB)
-
AN-555: Using the AD9709, AD9763, AD9765, AD9767 Dual DAC Evaluation Board
(pdf, 206 kB)
-
AN-534: Adding HART® Capability to the AD421, Loop-Powered 4 mA–20 mA DAC Using the 20C15 HART Modem
(pdf, 49 kB)
-
AN-420: 0: Using the AD9708/AD9760/AD9701/AD9764-EB Evaluation Board
(pdf, 227 kB)
-
AN-414: Low Cost, Low Power Devices for HDSL Applications
(pdf, 41 kB)
-
AN-412: Video-Standard Selection Circuit for the AD722 Using Low Cost Crystals
(pdf, 27 kB)
-
AN-351: Ask the Applications Engineer-2
(pdf, 286 kB)
Trimming Offset and Gain in A/D's and D/A's
-
AN-349: Keys to Longer Life for CMOS
(pdf, 89 kB)
Here's How CMOS Can be Protected Against Abuse
-
AN-348: Avoiding Passive-Component Pitfalls
(pdf, 931 kB)
The Wrong Passive Component Can Derail Even the Best Op Amp or Data Converter. Here Are Some Basic Traps to Watch For.
-
AN-345: Grounding for Low-and-High-Frequency Circuits
(pdf, 455 kB)
Know Your Ground and Signal Paths for Effective Designs. Current Flow Seeks Path of Least Impedance-Not Just Resistance....
-
AN-342: Analog Signal-Handling for High Speed and Accuracy.
(pdf, 468 kB)
Signal handling techniques for optimizing DAC and ADC performance.
-
AN-336: JPEG Compression
(pdf)
-
AN-333: Design and Layout of a Video Graphics System for Reduced EMI
(pdf, 1540 kB)
-
AN-328: Generate 4 Channels of Analog Output Using AD7542 12-Bit DAC and Control the Lot with Only 2 Wires
(pdf, 309 kB)
-
AN-326: Interfacing the AD7549 to the MCS-48 and MCS-51 Microcomputer Families
(pdf, 334 kB)
-
AN-325: 12-Bit Analog I/O Port Uses AD7549 Dual 12-Bit DAC and 8051 Microcomputer
(pdf, 318 kB)
-
AN-320B: CMOS Multiplying DACs and Op Amps Combine to Build Programmable Gain Amplifiers, Part 2
(pdf, 989 kB)
